Appliance Repair in Danville, Indiana

Refrigerator Repair in Danville

Washing Machine Repair in Danville, Indiana

Dryer Repair in Danville, Indiana

There’s a particular frustration that comes with a dryer that almost works — warm air, drum turning, cycle completing, but clothes still damp every single time. It’s the kind of problem Danville homeowners often chase for weeks, running extra cycles and assuming it’s the load size, before realizing something is genuinely wrong. Duncan Home Services cuts through the guesswork on dryer repairs throughout Danville and Hendricks County — gas and electric, all major brands, diagnosed correctly on the first visit.

Common dryer problems we repair:

• Dryer completely unresponsive — no power, no display
• Starts normally but shuts off after a few minutes
• Heating element cycling on and off instead of maintaining steady heat
• No heat at all despite drum spinning normally
• Clothes warm to the touch after a full cycle but still damp
• Thumping, squealing, or grinding that worsens over time
• Drum light working but start button producing no response
• Gas dryer igniting briefly then flame going out

We service all major brands including Whirlpool, LG, Samsung, GE, Maytag, Electrolux, and Speed Queen.

Pro Tip: Danville sits far enough west that many homes were built with dryer vents terminating on the west or north exterior walls to take advantage of prevailing wind directions — but those same walls accumulate more debris, bird nesting material, and lint cap buildup than south-facing exits. Check your exterior vent cap each spring to make sure it’s opening freely and isn’t obstructed. A stuck vent cap flap is one of the most common causes of restricted airflow that homeowners never think to check.

FAQ — Dryer Repair Q: My electric dryer runs on a 240-volt circuit. Could a tripped breaker cause it to run but not heat? A: Yes — and this is specific to electric dryers. A 240-volt circuit uses two breaker poles, and it’s possible for one pole to trip while the other stays on. The result is a dryer that has enough power to run the motor and controls but not enough to power the heating element. Check both breaker poles before assuming a component failure.

Q: My dryer has been squealing for months but still dries fine. Can I keep using it? A: You can, but you’re borrowing time. A persistent squeal is almost always a worn drum bearing, felt seal, or idler pulley — components that will eventually fail completely and can cause the drum to seize or the belt to snap. A squealing dryer that still works is a much cheaper repair than one that’s stopped entirely.

Range & Oven Repair in Danville

Danville’s food culture runs deep — from the restaurants and gathering spots around the courthouse square to the home kitchens where families have been cooking the same recipes for generations. When a stove or oven stops performing the way it should, it’s not just an appliance problem, it’s a disruption to something that matters. Duncan Home Services repairs gas, electric, and dual-fuel ranges throughout Danville and Hendricks County, with the technical depth to handle everything from a simple igniter swap to a full control board diagnosis.

Common stove and oven problems we repair:

• Oven temperature drifting significantly from the set point
• Bake element with visible breaks, blistering, or uneven glow
• Gas burner that clicks continuously without lighting
• Surface burner lighting on one side of the flame ring only
• Oven preheating normally but failing to maintain temperature
• Self-cleaning cycle failing to initiate or complete
• Display showing error codes after a power surge
• Oven door hinge worn — door not sitting flush or sealing properly

We service all major brands including Whirlpool, GE, LG, Samsung, KitchenAid, Bosch, and Frigidaire.

Pro Tip: Power fluctuations are more common in Danville’s older residential areas than most homeowners realize, and stove control boards are particularly vulnerable to voltage spikes. If your range started behaving erratically — random error codes, burners not responding consistently, display flickering — after a storm or power outage, the control board may have taken a hit. A surge protector for the range outlet is inexpensive and worth installing after any repair to protect the new components.

FAQ — Stove & Oven Repair Q: My oven works fine but the oven light won’t come on even after replacing the bulb. What’s wrong? A: If a new bulb doesn’t fix it, the issue is usually a failed light socket or a wiring connection that’s come loose — both common in older ranges that have experienced repeated heating and cooling cycles over the years. It’s a minor repair but worth addressing since the light socket failure can sometimes affect other oven functions on certain models.

Q: My gas range surface burners work perfectly but the oven produces no heat at all. Where do I start? A: On gas ranges, an oven that won’t heat while surface burners work normally almost always points to a failed oven igniter. The oven and surface burner ignition systems are independent — a failed oven igniter won’t affect the surface burners at all. It’s one of the most common gas range repairs we handle and typically resolved in a single visit.

Dishwasher Repair Services

A dishwasher running in a Danville home with hard water is fighting a battle on two fronts — mechanical wear over time and the constant mineral buildup that shortens component life and degrades performance long before an actual failure occurs. Homeowners often assume their dishwasher is broken when what it really needs is a combination of targeted maintenance and a specific repair. Duncan Home Services sorts out exactly what’s needed for dishwasher repairs throughout Danville and Hendricks County — no unnecessary parts, no guesswork, no return calls for the same problem.

Common dishwasher problems we fix:

• Dishes coming out with hard water spots, film, or food debris
• Water remaining in the bottom of the tub after the cycle
• Door gasket leaking — water on the kitchen floor after every cycle
• Dishwasher not advancing through cycle stages properly
• Upper rack dishes not getting clean — spray arm clogged or cracked
• Detergent dispenser door stuck closed during the wash
• Loud rattling or grinding from the pump or wash motor
• Control panel partially responsive — some buttons working, others not

We service all major brands including Bosch, KitchenAid, Whirlpool, GE, Maytag, Samsung, and LG.

DIY Tip: Hendricks County water runs moderately hard, and Danville homes on municipal supply see mineral buildup accumulate in dishwasher spray arm ports over time. Remove your spray arms every few months and run the ports under hot water — a toothpick clears the small holes faster than soaking alone. Clogged spray arm ports reduce water pressure to specific rack positions and are the most common cause of the upper rack not getting clean while the lower rack comes out fine.

FAQ — Dishwasher Repair Q: My dishwasher door latch broke and now the unit won’t start at all. Is that the only thing wrong? A: Most dishwashers won’t operate with a failed door latch — it’s a safety interlock, not just a mechanical closure. In most cases the latch is the sole issue and replacing it restores full function. We confirm the control board and door switch are also intact before closing out the repair.

Q: My dishwasher smells like burning plastic during the cycle. Should I stop using it? A: Yes — stop running it until it’s inspected. A burning plastic smell during operation can indicate a wiring issue, a failing pump motor with insulation breaking down, or a plastic utensil that’s fallen onto the heating element. The first two scenarios are potential fire or electrical hazards and shouldn’t be ignored.

Microwave Repair Danville, Indiana

Danville kitchens tend to be well-used, and a microwave that goes down takes more off the table than most households anticipate until it happens. Reheating, defrosting, and quick meal prep all stall simultaneously — and for over-the-range units that also handle kitchen ventilation, a broken microwave means cooking on the stovetop without any exhaust, which gets old fast. Duncan Home Services repairs built-in, over-the-range, and countertop microwaves throughout Danville and Hendricks County, diagnosing the actual failure rather than defaulting to replacement on every call.

Common microwave problems we repair:

• Microwave completely dead — no display, no response
• Powers on and runs but produces no heat
• Sparking or arcing inside the cooking cavity
• Turntable motor failed — plate not rotating during cooking
• Display flickering, partially lit, or showing error codes
• Door interlock switch failure preventing operation
• Exhaust fan not running on over-the-range models
• Keypad buttons registering incorrectly or not at all

We service all major brands including Whirlpool, GE, LG, Samsung, KitchenAid, and Bosch.

Pro Tip: Over-the-range microwaves in Danville homes that see heavy stovetop cooking accumulate grease in the door seal area and around the cavity edges faster than most homeowners clean them. Grease buildup near the door seal creates two problems — it degrades the seal over time, allowing microwave energy to escape, and it becomes a fire risk when the unit heats up during cooking. Wipe down the door seal and cavity edges weekly if you cook frequently on the range below.

FAQ — Microwave Repair Q: My microwave runs for about thirty seconds then shuts off on its own. What’s causing that? A: A microwave that runs briefly then cuts out is almost always a thermal cutout tripping to protect the unit from overheating — usually caused by a blocked or failed cooling fan. The magnetron and other high-voltage components generate significant heat during operation, and if the cooling fan isn’t moving air through the cabinet, the thermal cutout shuts everything down before damage occurs.

Q: I replaced the light bulb inside my microwave but it still won’t light up. Did I get a bad bulb? A: Possibly, but it’s more likely a failed door switch. Most microwaves use a door interlock switch to control the interior light — if that switch has failed, the light won’t illuminate regardless of the bulb condition. Door switches are among the most commonly replaced microwave components and are inexpensive to repair.

Compactor Repair in Danville, Indiana

When a trash compactor works, it earns its cabinet space every day. When it doesn’t, it becomes the most awkward appliance in the kitchen — too large to ignore, too specialized to fix yourself, and too inconvenient to leave broken while trash piles up. Duncan Home Services repairs built-in and freestanding trash compactors throughout Danville and Hendricks County, arriving with the diagnostic tools and common components to resolve most issues without a second trip.

Common trash compactor problems we repair:

• Unit completely unresponsive to the power switch
• Ram descends but won’t return to the home position
• Drive mechanism grinding or seizing mid-cycle
• Door refusing to latch — safety interlock preventing operation
• Gasket deteriorated — odors escaping the cabinet
• Control module not registering input correctly
• Ram motor worn, running slowly, or not engaging

We service all major brands including Whirlpool, KitchenAid, GE, and Broan.

Maintenance Tip: One pattern we see consistently in Danville compactor repairs is damage caused by compacting rigid materials — particularly wine and beer bottles that shatter under the ram and drive shards into the mechanism. Use proper compactor bags on every load, avoid compacting glass entirely if possible, and wipe the interior drawer and ram face down weekly. Five minutes of routine maintenance prevents the majority of the mechanical failures we get called to repair.

Garbage Disposal Repair in Danville, Indiana

Danville’s older homes were plumbed in an era when garbage disposals were considered a premium addition — which means many units currently running in these kitchens were installed during a renovation at some point and haven’t been touched since. An aging disposal that’s developed a slow leak under the sink, trips its reset button regularly, or has started grinding poorly isn’t going to fix itself. Duncan Home Services handles garbage disposal repairs throughout Danville and Hendricks County, giving homeowners a straight answer on whether repair or replacement makes more financial sense before any work begins.

Common garbage disposal problems we fix:

• Disposal completely unresponsive — no hum, no movement
• Humming without grinding — plate seized, motor straining
• Grinding performance noticeably weaker than it used to be
• Persistent leak from the flange, discharge outlet, or bottom seal
• Reset button tripping repeatedly after short use
• Foreign object rattling in the grinding chamber
• Disposal draining slowly despite clear drain lines

We service all major brands including InSinkErator, Moen, Waste King, and KitchenAid.

Safety Reminder: If your disposal has started leaking from the bottom of the unit rather than from the flange or drain connections, that almost always indicates a failed internal seal around the motor housing — a sign the unit has reached the end of its serviceable life. Running a disposal with a compromised motor seal allows water into electrical components and creates a shock hazard under the sink. Call Duncan Home Services for an assessment before continuing to use it.

FAQ — Garbage Disposal Repair Q: My disposal works fine but drains slowly even though my other sink drains normally. Is that a disposal problem or a plumbing problem? A: Slow drainage isolated to the disposal side of the sink typically points to buildup inside the disposal drain chamber or the discharge pipe connecting the disposal to the drain — not the main drain line. It’s a disposal service issue rather than a plumbing call, and we can clear it during the same visit.

Q: How do I know when it makes more sense to replace my disposal than repair it? A: Age and failure pattern are the two key factors. A disposal under 8-10 years old with a single identifiable failure is almost always worth repairing. A unit pushing 12-15 years that’s showing multiple issues simultaneously — leaking, grinding poorly, and tripping frequently — is telling you it’s done. We give you that assessment honestly before recommending anything.

Whether you’re near downtown Danville, the Blanton House, or the Hendricks County Historical Museum, our team can be there promptly. Contact our friendly customer service staff to book one of our next available repair appointments. Our highly trained professionals will arrive on time, equipped with all necessary tools and genuine parts to restore your disposal to working order.